We do not store credit card data on this site.
We use the latest PCI compatible payment processor to process your payments via our SSL enabled checkout.
You do not need a Paypal account to use the following cards
 |
Product Description
A 6V 180mm diameter early non o ring style flywheel that has had machining and balance work done.
Machined by Rimco to accept a 200mm clutch cover and then balanced to this Sachs 200mm new clutch cover.
This is compatible with earlier style crankshafts that run shim style seal against the crank face.
Bolt on vintage speed for a 40hp engine - a must if you have more power than a 180mm cover can handle.
Perhaps you're building a 36hp land speed challenge?
Starter teeth are NOT perfect and display some wear. Crank surface is ok/good. Could benefit a clean and bead blast to get super clean
Machined by Rimco to accept a 200mm clutch cover and then balanced to this Sachs 200mm new clutch cover.
This is compatible with earlier style crankshafts that run shim style seal against the crank face.
Bolt on vintage speed for a 40hp engine - a must if you have more power than a 180mm cover can handle.
Perhaps you're building a 36hp land speed challenge?
Starter teeth are NOT perfect and display some wear. Crank surface is ok/good. Could benefit a clean and bead blast to get super clean
